Dear All,
I recently bought altera De2 115 board from Altera. I am unable to download a program into the board. When I start the board and place in run mode all LED and Seven Segments are working fine. The board shows Error (209014): CONF_DONE pin failed to go high in device 1 when programmed
I checked for the device that I have used for generating the project as suggested by the Altera website but then also there is no outcome. The programmer stops at 41% percent program and shows fail.
Also, the control panel software that came with Altera board does not work. The software that came with de2 115 board is Quartus 10 which is pretty old thus, I downloaded version 17.1 for windows but I haven't had luck in programming the board with even simplest of the VHDL programming.
I recently bought altera De2 115 board from Altera. I am unable to download a program into the board. When I start the board and place in run mode all LED and Seven Segments are working fine. The board shows Error (209014): CONF_DONE pin failed to go high in device 1 when programmed
I checked for the device that I have used for generating the project as suggested by the Altera website but then also there is no outcome. The programmer stops at 41% percent program and shows fail.
Also, the control panel software that came with Altera board does not work. The software that came with de2 115 board is Quartus 10 which is pretty old thus, I downloaded version 17.1 for windows but I haven't had luck in programming the board with even simplest of the VHDL programming.