Dear All, I am new to Altera Cyclone V. As per the altera website , i downloaded and installed EDS. I followed the instruction for compiling the preloader in the EDS user guide. After compilation the "preloader-mkpimage.bin" got created. The size of the binary is 256KB. But in Cyclone V device handbook(Booting and configuration chapter), it is mentioned that the preloader binary size should be less than 64KB. I directly flashed the preloader-mkpimage.bin to SD card without giving the file to the mkpimage tool.I flashed the preloader to SD card using the following command:dd if=preloader-mkpimage.bin of=/dev/sdc.I got the following commands in the terminal:U-Boot SPL 2012.10 (May 25 2013 - 15:21:53)SDRAM : Initializing MMR registersSDRAM : Calibrationg PHYSEQ.C: Preparing to start memory calibrationSEQ.C: CALIBRATION PASSEDDESIGNWARE SD/MMC: 0spl: No MBR signature is found### ERROR ### Please RESET the board ###I didn't partition my mmc sd card. In cyclone V device handbook it is mentioned that A2 partition needs to be created. Anyone please tell me the procedure /commands to partition the mmc card and flashing preloader, uboot and uImage to mmc card.Thanks & Regards,Sowmya
↧