Dear Good people
My MAX 10 JTAG was working well but suddenly from yesterday it is showing some problem. When i push the button auto scan it is showing "Unable to scan device, Cant scan JTAG chain". After thar i tried to debug with JTAG Chain debugger and it showed 3 error message.
1.Error: JTAG chain problem detected
2.Error: The TDI connection to the first detected device UNKNOWN_20D10DD might be shorted to VCC or is an open circuit
3.Error: The TCK and TMS connections to the device before the first detected device UNKNOWN_20D10DD might have a problem
My development board is MAX 10M50DAF484C6GES. I have seen some thread regarding the same problem but could not figure out what they were exactly saying. It would be great to have some specific solution or advice. Thanks in advance
My MAX 10 JTAG was working well but suddenly from yesterday it is showing some problem. When i push the button auto scan it is showing "Unable to scan device, Cant scan JTAG chain". After thar i tried to debug with JTAG Chain debugger and it showed 3 error message.
1.Error: JTAG chain problem detected
2.Error: The TDI connection to the first detected device UNKNOWN_20D10DD might be shorted to VCC or is an open circuit
3.Error: The TCK and TMS connections to the device before the first detected device UNKNOWN_20D10DD might have a problem
My development board is MAX 10M50DAF484C6GES. I have seen some thread regarding the same problem but could not figure out what they were exactly saying. It would be great to have some specific solution or advice. Thanks in advance