Hello,
I am trying to use a Max 10, 10M02 (2K LEs) device. My design has a ROM, with the Initialization data in a MIF file.
However Analysis & Synthesis run fails with the message.. (I am using Quartus II 15.1.2, build 193)
"Error (16031): Current Internal Configuration mode does not support memory initialization or ROM. Select Internal Configuration mode with ERAM."
As per Max 10 device manual, for this particular device..
"The internal configuration scheme for 10M02 device (only) supports the following mode:
Single Compressed Image
Single Uncompressed Image"
I tried another device 10M08 and I do not get this message, as it has additional configuration mode options available (few of them allows Image generation, along with an Initialization file too. But as mentioned, 10M02 device does not offer those options).
So am I stuck with with using a bigger device, because of this issue or is there a way that I can still use the smaller 10M02?
Thanks,
I am trying to use a Max 10, 10M02 (2K LEs) device. My design has a ROM, with the Initialization data in a MIF file.
However Analysis & Synthesis run fails with the message.. (I am using Quartus II 15.1.2, build 193)
"Error (16031): Current Internal Configuration mode does not support memory initialization or ROM. Select Internal Configuration mode with ERAM."
As per Max 10 device manual, for this particular device..
"The internal configuration scheme for 10M02 device (only) supports the following mode:
Single Compressed Image
Single Uncompressed Image"
I tried another device 10M08 and I do not get this message, as it has additional configuration mode options available (few of them allows Image generation, along with an Initialization file too. But as mentioned, 10M02 device does not offer those options).
So am I stuck with with using a bigger device, because of this issue or is there a way that I can still use the smaller 10M02?
Thanks,