I'd like to use the I2C interface so I used the 'I2C Master'in Qsys.
I route the SCL and SDA outputs of the core to two GPIO pins of the
PMODA connector of my Max 10 Development Kit board. This does not work.
Nooutput from the pins at all.
Strangely enough, if I replace the two pins by twoon board LEDS
the latter light up, indicating that there are SCL and SDAsignals
getting generated.
Any idea how to get the PMODA working? I checked PMODA
independently with almost the same setup and it works fine.
This is the LED-code in the Verilog-file:
.i2c_opencores_0_export_sda_pad_io (USER_LED[2])
.i2c_opencores_0_export_scl_pad_io(USER_LED[3])
And of course very similar for the PMODA port:
.i2c_opencores_0_export_sda_pad_io(PMODA_IO[6])
.i2c_opencores_0_export_scl_pad_io (PMODA_IO[7])
Thanks in advance,
Jos
I route the SCL and SDA outputs of the core to two GPIO pins of the
PMODA connector of my Max 10 Development Kit board. This does not work.
Nooutput from the pins at all.
Strangely enough, if I replace the two pins by twoon board LEDS
the latter light up, indicating that there are SCL and SDAsignals
getting generated.
Any idea how to get the PMODA working? I checked PMODA
independently with almost the same setup and it works fine.
This is the LED-code in the Verilog-file:
.i2c_opencores_0_export_sda_pad_io (USER_LED[2])
.i2c_opencores_0_export_scl_pad_io(USER_LED[3])
And of course very similar for the PMODA port:
.i2c_opencores_0_export_sda_pad_io(PMODA_IO[6])
.i2c_opencores_0_export_scl_pad_io (PMODA_IO[7])
Thanks in advance,
Jos