When a scan jtag chain is performed on the devkit (all dip switches on default) after an image other than the factory build is programmed to the A10, the configuration flash is no longer seen in the jtag chain. Errors are reported back through the programmer that the flash is not supported by quartus.
We only do not see this issue when the factory default is programmed (i.e. customer image, board test builds, and example designs all produce this error).
Is this a known issue? If not, is it something in the rtl of the factory image that the customer is not including in their design?
Thanks
We only do not see this issue when the factory default is programmed (i.e. customer image, board test builds, and example designs all produce this error).
Is this a known issue? If not, is it something in the rtl of the factory image that the customer is not including in their design?
Thanks