Does Max10 SCE have no ability to "Select Internal Configuration mode with ERAM" ?

Hello,

I have a question.

I am using a 10M50SCE144C8G chip. (i.e. MAX 10 SCE chip) and Quartus Prime Version 17.0.0 Build 595 (04/25/2017) SJ Lite Edition.

I have my VHDL code loaded into CFM0 and that works fine.

I generated a hex file from my NIOS II code. I added that hex to my build in Qsys (under Memory initialization).

But the problem is when I synthesize the whole thing, I get an error :

"16031 Current Internal Configuration mode does not support memory initialization or ROM.
Select Internal Configuration mode with ERAM."

But... when i go into Device->Device and Pin Options->Configuration->Configuration Mode, i only see 2 options :

1. Single Compressed Image
2. Single Uncompressed Image

I do not see the option "Single uncompressed image with Memory Initialization" which would make the error above go away.

My question is :

Is there any way to flash my NIOS II code onto a Max 10 SCE chip?
If I cannot run NIOS II off internal flash, what use are these SCE chips?

Someone mentioned the above issue has been bug fixed in later updated of Quartus 2.
As in later than version 17.0.0.
Is that true?
Is the option "Single uncompressed image with Memory Initialization" for SCE chips shown in later Quartus versions?

Thanks