For Windows users of Altera's OpenCL 13.0 SDK, the driver installation steps differ depending on which board you use. The Windows OpenCL SDK installer does not install the driver automatically. After the installer completes the installation perform the following steps to install the appropriate driver:
Nallatech Board Driver:
1) Open a command line window
2) Type "aocl install" and allow the driver to install
Bittware Board Driver:
1) Navigate to %ALTERAOCLSDKROOT%/windows64/driver
2) Run install.bat with administrator privaleges
Note: For step 2 in either case to work you must not already have an actively loaded driver. To ensure the driver is not already loaded open the device manager and uninstall the Jungo Windriver and the driver listed under "Accelerators" before installing the new driver.
Nallatech Board Driver:
1) Open a command line window
2) Type "aocl install" and allow the driver to install
Bittware Board Driver:
1) Navigate to %ALTERAOCLSDKROOT%/windows64/driver
2) Run install.bat with administrator privaleges
Note: For step 2 in either case to work you must not already have an actively loaded driver. To ensure the driver is not already loaded open the device manager and uninstall the Jungo Windriver and the driver listed under "Accelerators" before installing the new driver.