I use C5EFP board, https://www.altera.com/products/boar...clone-v-e.html
I program the EPCQ with jic file, get Error (209025): Can't recognize silicon ID for device 1 when it load 87%, but I can load the .sof file successfully.
Then I read the Cyclone V E FPGA Development Board Reference Manual and schematic, the SW1 MSEL[4:0] need to be set as 10010, and also need to remove resistor R16 and R22, then connect resistor R18 and R23.
Do anyone meet the same problem on C5EFP too? Or is the way in the manual rightly described?
I program the EPCQ with jic file, get Error (209025): Can't recognize silicon ID for device 1 when it load 87%, but I can load the .sof file successfully.
Then I read the Cyclone V E FPGA Development Board Reference Manual and schematic, the SW1 MSEL[4:0] need to be set as 10010, and also need to remove resistor R16 and R22, then connect resistor R18 and R23.
Do anyone meet the same problem on C5EFP too? Or is the way in the manual rightly described?