I am absolutely new to FPGA devices, so please excuse me for novice questions.
I am designing a FPGA board using EP1C12Q240C8 of cyclone 1 device.
I am using orcad capture for designing the schematic. I found this particular library for this model from Altera site.
Now the problem is, in this model, there are 60 pins on each side of the FPGA, but in the orcad library given by altera, the pins are arranged haphazardly, not like the original device. I have attached a screenshot of the orcad library image.
please help me.
I am designing a FPGA board using EP1C12Q240C8 of cyclone 1 device.
I am using orcad capture for designing the schematic. I found this particular library for this model from Altera site.
Now the problem is, in this model, there are 60 pins on each side of the FPGA, but in the orcad library given by altera, the pins are arranged haphazardly, not like the original device. I have attached a screenshot of the orcad library image.
please help me.