I am trying to configure a EPCS1 through JTAG indirect. I receive the following message, which is as cryptic as the help.
Serial Flash Loader Active Serial Memory Interface on device 1 is not granted .
|
(ID: 209075) |
| CAUSE: |
You attempted to perform any operation when the Active Serial Memory Interface access granted signal in the SFL IP is set to active low. |
| ACTION: |
Set the SFL ASMI access granted signal to active high. |
I am using a cyclone I with an EPCS1. I can configure the FPGA, but can't program the device. I have double check the wiring.
Thanks for any help.