Hi,
in Quartus II 13 when trying to run a RTL functional simulation (eg. from the Simulation Waveform Editor Editor) nothing happens.
I think the setup is right (the design is in VHDL, compiled correctly, tool assignment is ModelSim-Altera, I even assigned an older Cyclone II device ...) but there is no way I could get this to work.
I would really appreciate some help on this as it's a quite fundamental tool of the University Program... and it makes Altera's "Introduction to Simulation
of VHDL Designs" tutorial wrong.
(the waveform simulation in ModelSim is just fine)
Thanks,
in Quartus II 13 when trying to run a RTL functional simulation (eg. from the Simulation Waveform Editor Editor) nothing happens.
I think the setup is right (the design is in VHDL, compiled correctly, tool assignment is ModelSim-Altera, I even assigned an older Cyclone II device ...) but there is no way I could get this to work.
I would really appreciate some help on this as it's a quite fundamental tool of the University Program... and it makes Altera's "Introduction to Simulation
of VHDL Designs" tutorial wrong.
(the waveform simulation in ModelSim is just fine)
Thanks,