Hi -
I have a Max V development kit that I am trying to learn how to use. It has been a long time since I have worked with digital hardware so forgive my stupidity. Anyway...
I am just going through the User Guide to get started. I tried to install Quartus II Web Edition, and the Max V CPLD development kit software. I believe these installed correctly, as did the USB-Blaster (do you have to plug the board in for that?). But when I try to run the Board Test System (Section 5) I do not get the same pull-down menu options as shown in Figure 5-1. I do get the "File" and "About" menus, but not the "Config" menu - which seems to be critical to most testing with the board. As a result, I cannot enable any of the tabs aside from GPIO and Power.
Has anyone else experienced this? How can it be fixed?
I have a Max V development kit that I am trying to learn how to use. It has been a long time since I have worked with digital hardware so forgive my stupidity. Anyway...
I am just going through the User Guide to get started. I tried to install Quartus II Web Edition, and the Max V CPLD development kit software. I believe these installed correctly, as did the USB-Blaster (do you have to plug the board in for that?). But when I try to run the Board Test System (Section 5) I do not get the same pull-down menu options as shown in Figure 5-1. I do get the "File" and "About" menus, but not the "Config" menu - which seems to be critical to most testing with the board. As a result, I cannot enable any of the tabs aside from GPIO and Power.
Has anyone else experienced this? How can it be fixed?