I want to see what is the delay from signal source to output after I do SignalProbe. The Quartus handbook said that
The SignalProbe source to output delays screen in the Timing Analysis section of the
Compilation Report displays the timing results of each successfully routed
SignalProbe pin
See page 5 of this document http://www.altera.com/literature/hb/...s_qii53008.pdf
But when I follow what this document said, I don't see this information in Quartus.
Any idea why? Thanks in advance.
I am using Quartus 10.1 on Linux platform.
Quote:
The SignalProbe source to output delays screen in the Timing Analysis section of the
Compilation Report displays the timing results of each successfully routed
SignalProbe pin
But when I follow what this document said, I don't see this information in Quartus.
Any idea why? Thanks in advance.
I am using Quartus 10.1 on Linux platform.