Hey everyone!
I want to simulate my NiosII software built with NiosII IDE with a simulation software (ModelSim \ Active-HDL).
I've done some research over several sites and doesn't find any information about simulating the sofware with break-points like i've done on my target board with the same software.
If I can't perform a simulation with breakpoints the whole thing is worthless cause it's impossible to debug the software without them.
Can anyone know how can I do that? Is it even possible?
By the way, I can't find any updated Altera tutorial concern simulating the NiosII embedded software on model-sim, if anyone has one I would appreciate sending it to me.
Thanks in advance, Omri.
I want to simulate my NiosII software built with NiosII IDE with a simulation software (ModelSim \ Active-HDL).
I've done some research over several sites and doesn't find any information about simulating the sofware with break-points like i've done on my target board with the same software.
If I can't perform a simulation with breakpoints the whole thing is worthless cause it's impossible to debug the software without them.
Can anyone know how can I do that? Is it even possible?
By the way, I can't find any updated Altera tutorial concern simulating the NiosII embedded software on model-sim, if anyone has one I would appreciate sending it to me.
Thanks in advance, Omri.