hello,
i am writing a 1024 point FFT code in system verilog using Modelsim Altera starter edition. the compilation of the code was a success but when i try to simulate the test code, all the modules gets properly loaded but then the software closes with exit code 9 warning. it says memory allocation failure even though i have a huge ram. furthermore when searching for the solution i came across one saying to add a clk but it wasn't of any help as i already had one:confused:
this is a really important part of my project:oops:. any kind of help is xxtremly appreciated.. plss reply asap:(
i am writing a 1024 point FFT code in system verilog using Modelsim Altera starter edition. the compilation of the code was a success but when i try to simulate the test code, all the modules gets properly loaded but then the software closes with exit code 9 warning. it says memory allocation failure even though i have a huge ram. furthermore when searching for the solution i came across one saying to add a clk but it wasn't of any help as i already had one:confused:
this is a really important part of my project:oops:. any kind of help is xxtremly appreciated.. plss reply asap:(