Hi All,
We have a custom Cyclone IV board with an SFP interfaced to the FPGA via SGMII on a standard Altera TSE. We also have an opencores i2c bus to control the moddef pins.
We have a uClinux build that works with the same PCB but with a standard GMII/MDIO interfaces to a Micrel PHY. This works fine.
Can anyone give me any assistance in what would be required to set up the drivers etc for SGMII rather than GMII?
If it helps I am using the device tree for kernel config.
Many thanks
Vern
We have a custom Cyclone IV board with an SFP interfaced to the FPGA via SGMII on a standard Altera TSE. We also have an opencores i2c bus to control the moddef pins.
We have a uClinux build that works with the same PCB but with a standard GMII/MDIO interfaces to a Micrel PHY. This works fine.
Can anyone give me any assistance in what would be required to set up the drivers etc for SGMII rather than GMII?
If it helps I am using the device tree for kernel config.
Many thanks
Vern