Hello,
I've got 2 sdram controllers connected to a NIOS II system.
These sdram-controllers are exactly the same (they address only different address-spaces) but when I want to display some signals in signaltap (called m_cmd[4] through m_cmd[0]) I cannot select the required signals from the first controller.
The first controller has signals called: m_cmd[0]~_Duplicate_1 while the second controller has the correct signal-names called: m_cmd[0], etc.
Does anybody have some idea why there is a difference between the signals of both controllers and which setting I could change to make the signals from the first controller available.
Best regards,
Wamor
I've got 2 sdram controllers connected to a NIOS II system.
These sdram-controllers are exactly the same (they address only different address-spaces) but when I want to display some signals in signaltap (called m_cmd[4] through m_cmd[0]) I cannot select the required signals from the first controller.
The first controller has signals called: m_cmd[0]~_Duplicate_1 while the second controller has the correct signal-names called: m_cmd[0], etc.
Does anybody have some idea why there is a difference between the signals of both controllers and which setting I could change to make the signals from the first controller available.
Best regards,
Wamor